Danfoss iC2 Application Manual page 169

Application Guide | iC2-Micro Frequency Converters
Data type:
uint16
P 5.6.15 Sync. High Starting Torque Time [s]
Use this parameter to set the high starting torque time for a PM motor in VVC+ mode.
Default value:
Size Related
Parameter
3020
number:
Data type:
uint16
P 5.6.16 Sync. High Starting Torque Current [%]
Use this parameter to set the high starting torque current for a PM Motor in VVC+ mode.
Default value:
Size Related
Parameter
3021
number:
Data type:
uint 32
Stop Settings (Menu Index 5.7)
7.6.6
P 5.7.1 Function at Stop
Use this parameter to select the drive function after a stop command or after the speed is ramped down to the level set in P 5.7.2 Min
Speed for Function at Stop [Hz].
Default value:
0 [Coast]
Parameter
180
number:
Data type:
enum
The following are the selections for the parameter.
Selection number Selection name
0 Coast
1 DC Hold/Motor Preheat
Danfoss A/S © 2024.03
Access type:
Parameter type:
Unit:
Access type:
Parameter type:
Unit:
Access type:
Parameter type:
Unit:
Access type:
Selection description
Leaves the motor in free mode
Energizes the motor with a DC-hold current (see P 5.7.6 DC Hold
Current %).
AB413939445838en-000301 / 130R1254 |
Read/Write
Range (0.00–60.00)
s
Read/Write
Range (0.0–200.0)
%
Read/Write
Selection
–
Read/Write
169