Danfoss iC2 Application Manual page 203

Application Guide | iC2-Micro Frequency Converters
Selection number Selection name
39 Start command
40 Drive stopped
42 Auto Reset Trip
50 Comparator 4
51 Comparator 5
60 Logic rule 4
61 Logic rule 5
83 Lost Load
P 8.4.2.3 Stop Controller
Select the condition (TRUE or FALSE) to deactivate the Smart Logic Controller.
Default value:
40
Parameter
1302
number:
Data type:
enum
The following are the selections for the parameter.
Selection number Selection name
0 FALSE
1 TRUE
2 Running
3 In range
4 On reference
7 Out of current range
8 Below I low
9 Above I high
16 Thermal warning
17 Mains out of range
18 Reversing
19 Warning
20 Alarm (trip)
21 Alarm (trip lock)
Danfoss A/S © 2024.03
Selection description
This event is True, if frequency converter is started by any means
(digital input or other).
This event is True, if frequency converter is stopped or coasted by
any means (digital input or other).
An auto reset is performed.
Use result of comparator 4 in logic rule.
Use result of comparator 5 in logic rule.
Use result of logic rule 4 in logic rule.
Use result of logic rule 5 in logic rule.
Lost load is performed.
Parameter type:
Unit:
Access type:
Selection description
Enters False in logic rule.
Enters True in logic rule.
See P 9.4.3.1 Function Relay [5] for description.
See P 9.4.3.1 Function Relay [7] for description.
See P 9.4.3.1 Function Relay [8] for description.
See P 9.4.3.1 Function Relay [12] for description.
See P 9.4.3.1 Function Relay [13] for description.
See P 9.4.3.1 Function Relay [14] for description.
See P 9.4.3.1 Function Relay [21] for description.
Mains voltage is outside the specified voltage range.
See P 9.4.3.1 Function Relay [25] for description.
A warning is active.
A trip alarm is active.
A trip lock alarm is active.
AB413939445838en-000301 / 130R1254 |
Selection
–
Read/Write
203