Modulation (Menu Index 2.4) - Danfoss iC2 Application Manual

Application Guide | iC2-Micro Frequency Converters
Parameter
1427
number:
Data type:
enum
The following are the selections for the parameter.
Selection number Selection name
0 Trip
1 Warning
P 2.3.16 Function at Inverter Overload
When the frequency converter issues an inverter overload warning, select whether to continue and probably trip the frequency
converter or derate the output current.
Default value:
0 [Trip]
Parameter
1461
number:
Data type:
enum
Selection number
0
1
P 2.3.17 Adjustable Temperature Warning
This parameter is used to warn about the heat sink temperature is high, that is, high ambient temperature or higher load. A trip could
happen if the condition is not rectified. When P 2.1.9 Heat Sink Temperatureplus the value set in the parameter exceed the maximum
value, HEATSINK_CLEAN_WARNING - bit 29 is set in P 5.1.10 Ext. Status Word. The control panel warning indicator light is not turned on
when the specified limit of the parameter is reached.
Default value:
Size Related
Parameter
442
number:
Data type:
uint8

Modulation (Menu Index 2.4)

7.3.3
P 2.4.2 Min. Switching Frequency
Set the lowest switching frequency allowed by the application.
Default value:
2 [2.0 KHz]
Parameter
1463
number:
Danfoss A/S © 2024.03
Unit:
Access type:
Selection description
Disable the protection filters and trip at the 1st fault.
Run the protection filters normally.
Parameter type:
Unit:
Access type:
Selection name
Trip
Derate
Parameter type:
Unit:
Access type:
Parameter type:
Unit:
AB413939445838en-000301 / 130R1254 |
V
Read/Write
Selection
–
Read/Write
Range (Size Related)
–
Read/Write
Selection
–
115