Danfoss iC2 Application Manual page 154

Application Guide | iC2-Micro Frequency Converters
Use this parameter to select whether the drive start function is controlled via the terminals (digital input) and/or via the fieldbus. This
parameter is active only when P 5.5.1.1 Control Place Selection is set to [0] Digital and control word.
Default value:
3 [Logic OR]
Parameter
853
number:
Data type:
enum
The following are the selections for the parameter.
Selection number Selection name
0 Digital input
1 Bus
2 Logic AND
3 Logic OR
P 5.5.2.5 Reversing Select
Use this parameter to select whether the drive reverse function is controlled via the terminals (digital input) and/or via the fieldbus.
This parameter is active only when P 5.5.1.1 Control Place Selection is set to [0] Digital and control word.
Default value:
3 [Logic OR]
Parameter
854
number:
Data type:
enum
The following are the selections for the parameter.
Selection number Selection name
0 Digital input
1 Bus
2 Logic AND
3 Logic OR
P 5.5.2.6 Set-up Select
154
| Danfoss A/S © 2024.03
Parameter type:
Unit:
Access type:
Selection description
A digital input triggers the start function.
A serial communication port or the fieldbus triggers the start
function.
The fieldbus/serial communication port and a digital input
trigger the start function.
The fieldbus/serial communication port or a digital input triggers
the start function.
NOTICE
Parameter type:
Unit:
Access type:
Selection description
A digital input triggers the reversing function.
A serial communication port or the fieldbus triggers the
reversing function.
The fieldbus/serial communication port and a digital input
trigger the reversing function.
The fieldbus/serial communication port or a digital input triggers
the reversing function.
Selection
–
Read/Write
Selection
–
Read/Write
AB413939445838en-000301 / 130R1254