Danfoss iC2 Application Manual page 148

Application Guide | iC2-Micro Frequency Converters
Operation Mode (Menu Index 5.4)
7.6.3
P 5.4.1 Application Selection
Use this parameter to select integrated application functions. When an application is selected, a set of its related parameters is set
automatically.
Default value:
20 [Speed Control Mode]
Parameter
16
number:
Data type:
enum
The following are the selections for the parameter.
Selection number
20
21
22
23
24
P 5.4.2 Operation Mode
Use this parameter to select the application control principle to be used.
Default value:
0 [Speed Open Loop]
Parameter
100
number:
Data type:
enum
The following are the selections for the parameter.
Selection number Selection name
0 Speed Open Loop
3 Process Closed Loop
4 Torque Open Loop
P 5.4.3 Motor Control Principle
Use this parameter to select U/f mode or VVC+ mode as motor control principle.
Default value:
1 [VVC+]
148
| Danfoss A/S © 2024.03
Parameter type:
Unit:
Access type:
Selection name
Speed Control Mode
Process Control Mode
Multi Speed Control Mode
Three Wire Control Mode
Torque Control Mode
Parameter type:
Unit:
Access type:
Selection description
Enable speed control (without feedback signal from motor)
with automatic slip compensation for almost constant speed at
varying loads. Compensations are active and can be disabled.
Enable the use of process control in the frequency converter.
Enable the use of torque open loop in the frequency converter
Parameter type:
Selection
–
Read/Write
Selection
–
Read/Write
Selection
AB413939445838en-000301 / 130R1254