Danfoss iC2 Application Manual page 65

Application Guide | iC2-Micro Frequency Converters
Table 20: Default Settings
Category
Operation mode
DI 1 - T13
DI 2 - T14
DI/O - T15
DI 3 - T17
DI 4 - T18
AI1 - T33
AI2 - T34
AO1 - T42
Relay
External reference
Speed Limit
Danfoss A/S © 2024.03
Parameter index Parameter name
5.4.2 Operation Mode
9.4.1.2 T13 Digital Input
9.4.1.3 T14 Digital Input
9.4.1.4 T15 Digital Input
9.4.1.5 T17 Digital Input
9.4.1.6 T18 Digital Input
9.5.2.1 T33 Mode
9.5.2.2 T33 High Voltage
9.5.2.3 T33 Low Voltage
9.5.2.6 T33 High Ref./Feedb.
Value
9.5.2.7 T33 Low Ref./Feedb.
Value
9.5.3.1 T34 Mode
9.5.3.4 T34 High Current
9.5.3.5 T34 Low Current
9.5.3.6 T34 High Ref./Feedb.
Value
9.5.3.7 T34 Low Ref./Feedb.
Value
9.5.1.1 T31 Mode
9.5.1.2 T31 Analog Output
9.4.3.1 Function Relay
5.5.3.5 Reference Function
5.5.3.7 Reference 1 Source
5.5.3.8 Reference 2 Source
5.5.3.9 Reference 3 Source
5.10.3 Speed Limit Mode
Torque Ctrl.
Default setting Parameter number
[4] Torque Open Loop 100
[8] Start 510
[0] No operation 511
[1] Reset 512
[14] Jog 513
[0] No Operation 515
[1] Voltage Mode 619
10V 611
0.07V 610
The value should be 615
set manually accord-
ing to application re-
quirement.
0 614
[0] Current Mode 629
20.00 mA 623
4.00 mA 622
50. If [1] North Amer- 625
ica is selected for
P 1.2.1 Regional
Settings, the default
value is 60.
0 624
[0] 0-20 mA 690
[100] Output Fre- 691
quency
[9] Fault 540
[0] Sum 304
[1] Analog Input 33 315
[0] No Function 316
[11] No Function 317
[0] No Function 421
AB413939445838en-000301 / 130R1254 |
65