Protection (Menu Index 2.3) - Danfoss iC2 Application Manual

Application Guide | iC2-Micro Frequency Converters
Parameter
1636
number:
Data type:
uint16
P 2.1.5 Output Current Limit %
View the inverter maximum current, which should match the nameplate data on the connected motor. The data is used for calculation of
torque and motor protection.
Default value:
Size Related
Parameter
1637
number:
Data type:
uint16
P 2.1.9 Heatsink Temperature
View the frequency converter heat sink temperature.
Default value:
0
Parameter
1634
number:
Data type:
int8
P 2.1.10 Real-time Switching Frequency
View the actual switching frequency. The actual switching frequency could not be same with the set value in P 2.4.3 Switching Frequency
due to internal derating.
Default value:
0
Parameter
1866
number:
Data type:
int8

Protection (Menu Index 2.3)

7.3.2
P 2.3.1 Overvoltage Controller Enable
Select to enable or disable Overvoltage Control (OVC), to reduce the risk of the frequency converter to trip due to an overvoltage on the
DC link caused by generative power from load.
Default value:
0
Parameter
217
number:
Data type:
enum
The following are the selections for the parameter.
Danfoss A/S © 2024.03
Unit:
Access type:
Parameter type:
Unit:
Access type:
Parameter type:
Unit:
Access type:
Parameter type:
Unit:
Access type:
Parameter type:
Unit:
Access type:
AB413939445838en-000301 / 130R1254 |
A
Read
Range (0.00–655.35)
A
Read
Range (-128–127)
°C
Read
Range (0–32)
kHz
Read
Selection
–
Read/Write
109