Table of Contents
Advertisement
Application Guide | iC2-Micro Frequency Converters
Application Software Overview
2
iC2-Micro Application Software Overview
2.1
The application software is the default and standard software delivered with the iC2-Micro Frequency Converters. The features are briefly
described in the following sections:
Basic Functions
l
Controllers
l
Protection Features
l
Software Tools
l
Basic Functions
2.2
Basic Functions Overview
2.2.1
The application software consists of a wide range of basic features which enables the drive to control any application using the iC2-Micro
drive.
Reference Handling
2.2.2
References from multiple sources, matching the needs to control the application, are freely definable.
Reference sources are:
Analog inputs
l
Digital inputs either as pulse input
l
Reference from a field bus
l
Internal settings
l
Local reference from control panel
l
Built-in potentiometer on control panel
l
Reference signals can be added generating the reference to the frequency converter. The final reference is scaled from -100% to 100%.
Two Setups
2.2.3
The frequency converter offers 2 setups. Each setup can be parameterized independently to match various application needs.
Switching between setups is possible during operation, allowing fast changeover.
Ramps
2.2.4
Linear, Sine ramp, Sine 2 ramps are supported in the frequency converter. The linear ramps provide a constant acceleration. The Sine
ramps provides a non-linear acceleration with soft transition at start and end of the acceleration process.
Quick Stop
2.2.5
In some situations, it may be required to stop the application in a quick way. For this purpose, the drive supports a specific deceleration
ramp time from the synchronous motor speed to 0 RPM.
Limit Rotation Direction
2.2.6
The rotational direction of the motor can be preset to run in 1 direction only (clockwise or counterclockwise), avoiding unintended
rotation direction.
14
| Danfoss A/S © 2024.03
AB413939445838en-000301 / 130R1254
Advertisement
Table of Contents
