Danfoss iC2 Application Manual page 190

Application Guide | iC2-Micro Frequency Converters
Default value:
0 [Do not reset]
Parameter
1506
number:
Data type:
enum
The following are the available selections for the parameter.
Selection number
0
1
P 6.1.9 Reset Running Hours Counter
Use this parameter to reset the Running Hours counter to zero (see P 6.1.3 Running Hours).
Default value:
0 [Do not reset]
Parameter
1507
number:
Data type:
enum
The following are the selections for the parameter.
Selection number
0
1
P 6.1.10 Internal Fault Reason
Use this parameter to view a description of the error. This parameter is used in combination with fault 38 Internal Fault.
Default value:
0
Parameter
1531
number:
Data type:
int16
P 6.1.11 Fault Log: Time
Use this parameter to view the time when the logged event occurred. Time is measured in seconds from drive start-up.
Default value:
0
Parameter
1532
number:
Data type:
uint32
190
| Danfoss A/S © 2024.03
Parameter type:
Unit:
Access type:
Selection name
Do Not Reset
Reset Counter
Parameter type:
Unit:
Access type:
Selection name
Do Not Reset
Reset Counter
Parameter type:
Unit:
Access type:
Parameter type:
Unit:
Access type:
Selection
–
Read/Write
Selection
–
Read/Write
Range (-32767–32767)
–
Read
Range (0–2147483647)
s
Read
AB413939445838en-000301 / 130R1254