Table of Contents
Advertisement
Application Guide | iC2-Micro Frequency Converters
Changing Selections in a Parameter
In this example, the P 5.5.4.1 Ramp 1 Type Selector is considered.
Figure 7
shows an overview of the relevant screens when changing the selections in a parameter.
OK
OK
Figure 7: Changing Selections in a Parameter
1.
Press the Up/Down buttons to go to the parameter.
2.
Press OK to view the current selection setting.
3.
Press OK to modify selection.
The selection numbers begin to flash.
4.
Use the Up/Down button to browse through the selection numbers.
5.
Press OK at the required selection number.
The flash stops.
Changing Parameter Value
In this example, the P 5.5.4.2 Ramp 1 Accel. Time is considered.
Figure 8
shows an overview of the relevant screens when changing the value of a parameter.
OK
Figure 8: Changing Parameter Value
1.
Press the Up/Down button to go to the parameter.
2.
Press OK to view the current parameter value.
3.
Press OK again to change the value of parameter.
The last bit of the value flashes and shows the location of the cursor.
4.
To move the cursor to the left, use the left arrow button of the control panel.
The flashing indicates the active location of the cursor, at the digit.
5.
Use the Up/Down buttons of the control panel to increase or decrease the value of the digit where the cursor is active.
6.
Press OK to confirm the changes.
Danfoss A/S © 2024.03
OK
OK
OK
AB413939445838en-000301 / 130R1254 |
27
Advertisement
Table of Contents
