Danfoss iC2 Application Manual page 242

Application Guide | iC2-Micro Frequency Converters
Selection number Selection name
56 Heat Sink Cleaning Warning, High
60 Comparator 0
61 Comparator 1
62 Comparator 2
63 Comparator 3
64 Comparator 4
65 Comparator 5
70 Logic rule 0
71 Logic rule 1
72 Logic rule 2
73 Logic rule 3
74 Logic rule 4
75 Logic rule 5
80 SL digital output A
81 SL digital output B
160 No Fault
161 Running Reverse
165 Local Ref. Active
166 Remote Ref. Active
167 Start Command Active
168 Drive in Local Mode
169 Drive in Remote Mode
193 Sleep Mode
194 Lost Load Function
242
| Danfoss A/S © 2024.03
Selection description
Activated when the heat sink temperature is not lower than the
calculated value. The calculated Value is equal to the maximum
value of P 2.1.9 Heat Sink Temperature minus the current value of
P 2.1.9 Heat Sink Temperature.
Use result of comparator 0 in logic rule.
Use result of comparator 1 in logic rule.
Use result of comparator 2 in logic rule.
Use result of comparator 3 in logic rule.
Use result of comparator 4 in logic rule.
Use result of comparator 5 in logic rule.
Use result of logic rule 0 in logic rule.
Use result of logic rule 1 in logic rule.
Use result of logic rule 2 in logic rule.
Use result of logic rule 3 in logic rule.
Use result of logic rule 4 in logic rule.
Use result of logic rule 5 in logic rule.
See P 8.4.6.2 Action. The output goes high whenever the smart
logic action [38] Set digital out A high is executed. The output
goes low whenever the smart logic action [32] Set digital out A
low is executed.
See P 8.4.6.2 Action. The output goes high whenever the smart
logic action [39] Set digital out B high is executed. The output
goes low whenever the smart logic action [33] Set digital out B
low is executed.
The output is high when no alarm is present.
The output is high when the frequency converter is running
counterclockwise (the logical product of the status bits Running
AND Reverse).
The output is high when local reference is activated.
The output is high when remote reference is activated.
The output is high when there is an active start command, and
no stop command is active.
The output is high when the frequency converter is in Local
mode.
The output is high when the frequency converter is in Remote
mode.
The frequency converter/system has entered sleep mode.
A lost-load condition is detected.
AB413939445838en-000301 / 130R1254