Configure The Ping Responder Service - Digi IX14 User Manual

Services
[ 4] 0.00-1.00
[ 4] 1.00-2.00
[ 4] 2.00-3.00
[ 4] 3.00-4.00
[ 4] 4.00-5.00
[ 4] 5.00-6.00
[ 4] 6.00-7.00
[ 4] 7.00-8.00
[ 4] 8.00-9.00
[ 4] 9.00-10.00
- - - - - - - - - - - - - - - - - - - - - - - - -
[ ID] Interval
[ 4] 0.00-10.00
[ 4] 0.00-10.00
iperf Done.
$

Configure the ping responder service

Your IX14 device's ping responder service replies to ICMP and ICMPv6 echo requests. The service is
enabled by default. You can disable the service, or you can configure the service to use an access
control list to limit the service to specified IP address, interfaces, and/or zones.
To enable the iPerf3 server:

WebUI
1. Log into the IX14 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Services > Ping responder.
The ping responder service is enabled by default. Click Enable to disable all ping responses.
IX14 User Guide
sec 26.7 MBytes 224 Mbits/sec
sec 28.4 MBytes 238 Mbits/sec
sec 29.8 MBytes 250 Mbits/sec
sec 31.2 MBytes 262 Mbits/sec
sec 32.1 MBytes 269 Mbits/sec
sec 32.5 MBytes 273 Mbits/sec
sec 33.9 MBytes 284 Mbits/sec
sec 33.7 MBytes 282 Mbits/sec
sec 33.5 MBytes 281 Mbits/sec
sec 33.2 MBytes 279 Mbits/sec
Transfer Bandwidth
sec 315 MBytes 264 Mbits/sec
sec 313 MBytes 262 Mbits/sec
Configure the ping responder service
8 2.68 MBytes
29 1.39 MBytes
0 1.46 MBytes
0 1.52 MBytes
0 1.56 MBytes
0 1.58 MBytes
0 1.60 MBytes
0 1.60 MBytes
0 1.60 MBytes
0 1.60 MBytes
Retr
37 sender
receiver
428