Adjusting Front Field Lights - MacDon M2170 Operator's Manual

3. Adjust the lights by hand as required. Loosen/tighten the
nuts if necessary:
• Tighten hinge nut (A) to 7.5 Nm (66 lbf·in).
• Tighten mounting nuts (B) to 27 Nm (239 lbf·in).
NOTE:
Tightening mounting nuts (B) requires two people. To
access mounting nuts (B), remove the cab-forward sun
shade, and then open the access panel in the headliner.

Adjusting Front Field Lights

Adjust field lights when in the field (or equivalent) to best suit Operator preference.
DANGER
To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key from the ignition before leaving the operator's seat for any reason.
1. Shut down the engine, and remove the key from the ignition.
2. Hold onto handholds (A) on the cab front corners, and
stand on the header anti-slip strips.
NOTE:
The header is not shown in the illustration.
262170
MAINTENANCE AND SERVICING
Figure 5.202: Left Cab-Forward Headlight – Right
Opposite
Figure 5.203: Windrower in Cab-Forward
480
A
B
A
Revision A