Changing Wheel Drive Lubricant - 12 Bolt (Optional) - MacDon M2170 Operator's Manual

Hide thumbs Also See for M2170:

Table of Contents

1. Park the windrower on level ground and position the

windrower so drain plug (B) is at the lowest point.

2. Shut down the engine, and remove the key from

the ignition.

3. Place a container (about 2 liters [2 quarts]) under lower

drain plug (B).

4. Remove plugs (A) and (B), and drain the lubricant into

the container.

5. Dispose of the oil in a manner that complies with local rules

and regulations.

6. After the lubricant has drained completely, position the

windrower so that ports (A) and (B) on the wheel are

horizontally level with the center of hub (C) as shown.

7. Add lubricant. For instructions, refer to

Wheel Drive Lubricant – 10 Bolt, page

8. Reinstall all plugs and torque them to 24 Nm (216 lbf·in).

5.6.8 Changing Wheel Drive Lubricant – 12 Bolt (Optional)

The wheel drive lubricant should be changed after the first 50 hours and every 1000 hours or annually, whichever occurs

first. Change the lubricant when it is warm.

To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the

key from the ignition before leaving the operator's seat for any reason.

MAINTENANCE AND SERVICING

Figure 5.45: Drive Wheel – 10 Bolt

5.10.5 Adding

Figure 5.46: Drive Wheel

Troubleshooting