Changing Wheel Drive Lubricant - 10 Bolt - MacDon M2170 Operator's Manual

Hide thumbs Also See for M2170:

Table of Contents

4. Remove drain plug (A) and allow the lubricant to

finish draining.

5. Inspect the drain plug. Small metal shavings are normal. If

there are any larger metal pieces, Contact your MacDon

6. Reinstall drain plug (A), and remove check plug (B).

7. Add lubricant until the oil level reaches check plug (B). For

lubricant specifications, refer to

and System Capacities, page

8. Reinstall check plug (B).

9. Operate the engine at low idle, and check for leaks at the

check plug and drain plug.

5.6.7 Changing Wheel Drive Lubricant – 10 Bolt

The wheel drive lubricant should be changed after the first 50 hours and every 1000 hours or annually, whichever occurs

first. Change the lubricant when it is warm.

To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the

key from the ignition before leaving the operator's seat for any reason.

MAINTENANCE AND SERVICING

5.1.2 Lubricants, Fluids,

Figure 5.43: M2170 - Engine Gearbox

Figure 5.44: M2260 - Engine Gearbox

Troubleshooting