Table of Contents
Advertisement
3. To adjust the KNIFE PRESSURE ALARM set point, press
arrows (A) until the desired value is shown.
NOTE:
The alarm will be set off more often at a lower setting and
less often at a higher setting. The factory setting is 245 bar
(3600 psi).
4.7.4 Setting Float Options with Fixed Deck
When using an auger or rotary header, the DECK SHIFT buttons can be used to store three float settings. This is useful
when ground conditions vary, or when having one side lighter is desirable (such as cutting along wheel tracks or irrigation
borders).
DANGER
Ensure that all bystanders have cleared the area.
1. Start the engine and use HEADER TILT switches (A) and (B)
on the ground speed lever (GSL) to set header tilt to the
mid-range position.
262170
OPERATION
Figure 4.462: Knife Adjust Page
B
Figure 4.463: GSL
338
A
A
Revision A
Advertisement
Table of Contents
Troubleshooting
