Fuel/Water Separator; Removing Water From Fuel System - MacDon M2170 Operator's Manual

Hide thumbs Also See for M2170:

Table of Contents

3. Clean the area around filler cap (A). Turn the cap

counterclockwise to unlock it. Remove the cap.

4. Carefully pour in the new oil. A funnel is recommended to

avoid spillage. For oil specifications, refer to

Lubricants, Fluids, and System Capacities, page

Do NOT fill above the HIGH mark.

5. Replace oil filler cap (A) and turn it clockwise until it is snug.

6. Check the oil level. For instructions, refer to

7. Close the hood. For instructions, refer to

5.7.2 Fuel/Water Separator

A fuel/water separator is incorporated into the primary fuel filter. The separator is equipped with a drain and a sensor that

detects water in the fuel and displays an alert on the HarvestTouch

separator daily or at any time the Water In Fuel (WIF) light illuminates on the display.

To remove water from the fuel system, refer to

Water in the fuel system can result in damage to the windrower's engine. If water is detected in the fuel system, it must be

removed immediately.

To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the

key from the ignition before leaving the operator's seat for any reason.

1. Shut down the engine, and remove the key from the ignition.

2. Open the hood. For instructions, refer to

MAINTENANCE AND SERVICING

Figure 5.61: Oil Filler Cap

5.7.1 Checking Engine Oil Level, page

5.3.2 Closing Hood, page

Display. Drain the water and sediment from the

Removing Water from Fuel System, page

5.3.1 Opening Hood, page