Programming Eco Engine Control - MacDon M2170 Operator's Manual

Table 4.1 Engine Start Troubleshooting (continued)
Problem
Wiring is shorted or the circuit breaker is
open
Faulty fuel injectors
Aftertreatment error on start up

Programming Eco Engine Control

The engine speed can be programmed to operate at reduced rpm to lower fuel and diesel exhaust fluid (DEF) consumption,
and to reduce in-cab noise levels.
The set-point for the engine speed can be adjusted in
increments of 100 rpm from 1800 to 2300 rpm in the ECO RPM
menu. While the header is engaged, the system can be
activated and deactivated (depending on field conditions) using
the Eco Engine Control (EEC) button (A) on the console. When
the engine is running at less than full throttle, you will notice a
small reduction in the maximum reel, draper, and ground
speeds.
The EEC feature is turned ON or OFF by pressing EEC button (A)
on the operator's console. EEC will only be available when the
header is engaged. The GREEN LEAF symbol on the
™
HarvestTouch Display indicates that the EEC is active. If EEC is
turned OFF, or the header is disengaged, the LEAF symbol will
appear grayed out. The EEC throttle limit can be adjusted at
any time.
1. To open the ECO RPM page on the HarvestTouch
press and hold MENU (A) for approximately 3 seconds.
2. Select the desired rpm from list (B), and confirm your
selection by pressing checkmark.
262170
OPERATION
• Check the continuity of the wiring and the breaker; manually reset
the circuit breaker
• Contact a MacDon Dealer
• Check diesel exhaust fluid (DEF) coolant hose routing, ensure the
coolant pressure lines, marked with red cable ties, are connected
together, and not crossed with the return line.
Figure 4.19: Eco Engine Control (EEC) Button
™
Display,
Figure 4.20: HarvestTouch
126
Solution
A
B
A
™
Display
1014733
Revision A