Table of Contents
Advertisement
7. Press HORN button (A) three times.
8. Turn IGNITION switch (B) to the ON position.
™
HarvestTouch
Display (C) will light up. Wait for WAIT TO
START (WTS) symbol (D) to disappear.
IMPORTANT:
Over-crank protection symbol (E) will appear if the starter
has been disabled due to overheating.
9. Ensure that red PARK symbol light (F) is ON and that there
are no error messages on the screen.
10. Turn the IGNITION switch to crank position (A).
IMPORTANT:
Do NOT move the GSL out of PARK until the hydraulic oil
temperature is at least 32°C (90°F). To check the hydraulic
oil temperature, swipe right on home page area (B) until
the page displays hydraulic oil temperature (C).
IMPORTANT:
• Do NOT operate the starter for longer than 15 seconds
at a time.
• If the engine does not start, wait at least 2 minutes
before you attempt to start the engine again.
• If the engine is cranked for longer than 30 seconds in a
2-minute period, the windrower's computer will lock
the starter circuit, and the over-crank protection symbol
will appear on the display. Wait for the over-crank
protection symbol to disappear before attempting to
crank the engine again.
• If the engine still does not start, refer to
Troubleshooting Engine Starting Problems, page
NOTE:
When the engine is running and the header is not engaged,
™
the HarvestTouch
Display will show header disengaged
page (B).
262170
OPERATION
F
Figure 4.16: Console and HarvestTouch
125.
Figure 4.17: HarvestTouch
124
C
D
™
Display
A
B
C
™
Display
A
B
E
Revision A
Advertisement
Table of Contents
Troubleshooting
