15. Disengage the safety props on both lift cylinders as follows:
a.
Turn lever (A) away from the header to raise the safety
prop until the lever locks into the vertical position.
b. Repeat the previous step for the opposite cylinder.
NOTE:
If the safety prop will NOT disengage, raise the header to
release the prop.
16. Start the engine, and press HEADER DOWN switch (A) on
the GSL to fully lower the header.
17. Select FLOAT ADJUST (A).
262170
OPERATION
Figure 4.299: Safety Prop Lever
A
Figure 4.300: GSL
Figure 4.301: HarvestTouch
263
A
A
™
Display
Revision A