Table of Contents
Advertisement
28. Reinstall clevis pin (A) through support (C) and secure it
with hairpin (B). Repeat this step for the opposite side of
the header.
Removing Forming Shield from the Windrower
The forming shield controls the width and placement of the windrow. The instructions in this section will show you how to
properly remove the forming shield from the windrower.
DANGER
To prevent bodily injury or death from the unexpected start-up of the machine, always stop the engine and remove the
key from the ignition before making adjustments to the machine.
NOTE:
It is NOT always necessary to remove the forming shield after detaching the header from the windrower.
1. Shut down the engine, and remove the key from the ignition.
2. Mark the strap location, remove and retain hairpin (A) and
washer (B) from straight pin (C).
3. Pull rubber strap (D) away from straight pin (C).
4. Lower the rear end of the forming shield.
5. Reinstall washer (B) and hairpin (A) on straight pin (C).
6. Repeat Step
2, page 256
opposite windrower leg.
262170
to Step
5, page 256
on the
OPERATION
Figure 4.286: Header Support
Figure 4.287: Rubber Strap Securing Forming Shield
onto Windrower Leg
256
C
A
B
C
B
D
A
Revision A
Advertisement
Table of Contents
Troubleshooting
