Table of Contents
Advertisement
4. Engage the safety props on both lift cylinders as follows:
a.
Pull lever (A) toward you to release it, and then rotate
it toward the header to lower the safety prop onto the
cylinder.
b. Repeat the previous step for the opposite lift cylinder.
IMPORTANT:
Ensure that the safety props engage over the cylinder piston
rods. If the safety prop does NOT engage properly, raise the
header until the safety prop fits over the rod.
5. Remove hairpin (A) from clevis pin (B). Remove the clevis
pin from header support (C) on both sides of the header.
6. Windrowers with self-aligning center-link: Release center-
link latch (A).
262170
OPERATION
Figure 4.267: Safety Prop Lever
Figure 4.268: Header Supports
Figure 4.269: Center-Link
248
C
B
A
A
A
Revision A
Advertisement
Table of Contents
Troubleshooting
