Table of Contents
Advertisement
4. Retrieve hydraulic hoses (A) from the header and route the
hose bundle under the windrower frame.
NOTE:
Adding anti-seize compound to the hose holder pin will
make future removal easier.
5. Insert pin (B) into hole (C) in the windrower frame.
IMPORTANT:
Route the hydraulic hoses as straight as possible, avoiding
wear points that could damage the hoses. To prevent
abrasion damage, the hoses should have enough slack to
pass by the multicoupler bracket without contacting it. To
adjust the slack in the hoses, loosen the clamps below
pin (B), adjust the hoses, then retighten the hose holder.
6. If using hard-plumbed fittings (A), proceed to Step
231. If using quick couplers (B), proceed to Step
231.
262170
OPERATION
Figure 4.226: Hose Support Attachment
7, page
8, page
Figure 4.227: Hard-Plumbed Fittings Compared to
Quick Couplers
230
B
C
A
A A
A B
Revision A
Advertisement
Table of Contents
Troubleshooting
