Table of Contents
Advertisement
6. When stage one of the calibration is complete, press PLAY
icon (A) on the screen to continue with stage two of the
calibration process.
7. When stage two of the calibration is complete, press
RESUME icon (A) on the screen to configure the HEADER
FLOAT setting, or press HOME or BACK button (not shown)
to exit.
NOTE:
The engine speed returns to the speed prior to calibration
when stage two calibration is complete.
NOTE:
If the voltage of any sensor falls below its acceptable range
during calibration, a message appears after completing the
calibration with a list of sensors reporting out-of-range
voltages. Adjust the sensors as needed and repeat the
calibration process from the beginning.
262170
OPERATION
Figure 4.366: Calibration Page
Figure 4.367: Calibration Page
Figure 4.368: Sample of Failed Calibration Display
Message
291
A
A
Revision A
Advertisement
Table of Contents
Troubleshooting
