Checking Wheel Drive Lubricant Level - 10 Bolt; Checking Wheel Drive Lubricant - 12 Bolt (Optional) - MacDon M2170 Operator's Manual

2. Remove secondary filter element (A) from the canister.
NOTE:
For filter specifications, refer to
page 356.
3. Insert new secondary filter element (A) into the canister,
seal first, and push it until the seal is seated inside the
canister.
4. Install the primary filter. For instructions, refer to
Primary Engine Air Filter, page
5.10.3 Checking Wheel Drive Lubricant Level – 10 Bolt
Check the wheel drive lubricant level every 250 hours or annually.
DANGER
To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key from the ignition before leaving the operator's seat for any reason.
1. Park the windrower on level ground.
2. Position the windrower so that plugs (A) and (B) are
horizontally aligned with center (C) of the hub.
WARNING
Use caution when removing plug as there may be pressure in
the drive.
3. Remove plug (A) or (B). The lubricant should be visible
through the port or running out slightly. If lubricant needs
5.10.5 Adding Wheel Drive Lubricant –
to be added, refer to
10 Bolt, page 424.
NOTE:
The type of lubricant used after the first lubricant change is
different from the factory supplied lubricant.
4. Reinstall the plugs and torque them to 24 Nm (216 lbf·in).
5.10.4 Checking Wheel Drive Lubricant – 12 Bolt (Optional)
Check the wheel drive lubricant level every 250 hours or annually.
DANGER
To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key from the ignition before leaving the operator's seat for any reason.
262170
MAINTENANCE AND SERVICING
5.1.5 Filter Part Numbers,
Installing
420.
423
A
Figure 5.109: Secondary Air Filter
A
Figure 5.110: Drive Wheel – 10 Bolt
B
C
Revision A