MacDon M2170 Operator's Manual page 303

5. Remove hairpin (B) from clevis pin (A). Remove the clevis
pin from header support (C) on each side of the header.
6. Windrowers with self-aligning center-link: Release center-
link latch (A).
7. Disengage the safety props on both lift cylinders as follows:
a. Turn lever (A) away from the header to raise the safety
prop until the lever locks into the vertical position.
b. Repeat the previous step for the opposite cylinder.
NOTE:
If the safety prop will NOT disengage, raise the header to
release the prop.
8. Start the engine.
262170
OPERATION
Figure 4.336: Header Support
Figure 4.337: Center-Link
Figure 4.338: Safety Prop Lever
279
B
A
A
C
A
Revision A