Adjusting Reel Speed - MacDon M2170 Operator's Manual

11. On the side that is higher, remove nut, washer, and bolt (A)
that attaches shims (B) to the linkage.
12. Remove one or both of shims (B) and reinstall
hardware (A).
13. Repeat Step 3, page 315
cylinders and check the header level.
14. If additional adjustment is required, repeat Step
315 to Step 11, page 316, and install one of the removed
shims on the opposite linkage.
15. Reset the header float. For instructions, refer to
NOTE:
Additional shims are available from your Dealer.

4.6.6 Adjusting Reel Speed

Reel speed is displayed in either rpm, mph, or km/h (depending on the global units selection). The default reel speed is
60 rpm and can be set to auto or manual mode.
• AUTO mode: Minimum reel speed and operating reel speed differential relative to ground speed are set, and the reel
speed is maintained. For instructions, refer to
• MANUAL mode: Reel speed is set and maintained regardless of ground speed. For instructions, refer to
Speed in Manual Mode, page
NOTE:
Both speed modes work with the One-Touch-Return feature. For example, button A on the GSL can be set for MANUAL
mode and button B can be set for AUTO mode. For instructions, refer to
262170
to Step 7, page 315 to rephase the
8, page
Setting Float, page
Setting Reel Speed in Auto Mode, page
318.
OPERATION
A
B
Figure 4.415: Lift Linkage Shims
297.
One-Touch-Return Buttons, page
316
317.
Setting Reel
83.
Revision A