Installing Return Oil Filter - MacDon M2170 Operator's Manual

Installing Return Oil Filter

The return oil filter removes particulate contaminants from the oil returning from the fan drive, lift circuits, and drive
circuits.
NOTE:
For filter specifications, refer to
NOTE:
The image shows the filter head removed for component clarity.
1. Clean gasket groove (B) in filter head (A).
2. Apply a thin film of clean oil to new filter gasket (C).
IMPORTANT:
Do NOT pre-fill the filter before installation as this may
introduce unfiltered oil into the system.
3. Install new gasket (C) into groove (B) in filter head (A).
4. Screw new filter (D) onto the filter head until the gasket
just contacts the filter.
262170
MAINTENANCE AND SERVICING
5.1.5 Filter Part Numbers, page 356.
B
D
Figure 5.52: Return Filter
391
A
C
Revision A