MacDon M2170 Operator's Manual page 427

1. Park the windrower on a level surface.
2. Shut down the engine, and remove the key from the ignition.
NOTE:
If the engine is hot, wait 10 minutes before checking the gearbox lubricant level to allow the lubricant to cool and
settle in the gearbox's sump.
3. Open the hood. For instructions, refer to
4. To check the gearbox oil level, remove dipstick (A) located
next to the breather cap tube and wipe it clean.
5. Reinsert the dipstick into the gearbox fully to get a clean
level reading. Remove the dipstick again and check the
level; the lubricant should be between ADD line (C) and
FULL line (D).
NOTE:
Adding 200 mL (6.75 oz.) of gearbox lubricant will raise the
level from the ADD line to the FULL line.
6. If lubricant is needed, remove breather cap (B) and add
lubricant until the lubricant level reaches the FULL line on
the dipstick.
NOTE:
For oil requirements, refer to the inside back cover.
7. Replace dipstick (A) into the gearbox and press it in to
secure.
8. Replace breather cap (B) and tighten it.
262170
MAINTENANCE AND SERVICING
5.3.1 Opening Hood, page
Figure 5.70: Gearbox Lubricant Check Plug
403
362.
D C
B
A
Revision A