Table of Contents
Advertisement
Figure 4.373:
5. The list of settings will vary according to the type of header attached to the windrower. The illustration shows the
settings available to a D2 Series Draper Header. Select and adjust the following settings as required:
• (A) CUT WIDTH
• (B) RAISE LOWER RATES
• (C) ATTACHMENTS – Use this page to enable (or disable) attachments such as the double draper drive and swath
compressor.
6. Calibrate the header if attaching it to the windrower for the first time, or if there is another reason to calibrate the
header. For instructions, refer to
262170
OPERATION
4.4.6 Calibrating Header on HarvestTouch
294
A
B
C
™
Display, page
285.
Revision A
Advertisement
Table of Contents
Troubleshooting
