MacDon M2170 Operator's Manual page 213

9. Retrieve draper drive and reel control multicoupler (A) from
the hydraulic hose management system.
10. Push knob (B) on the hydraulic receptacle and pull
handle (C) fully away from the windrower.
11. Open cover (D) and position the coupler onto the
receptacle. Align the pins in the coupler with the slots in
handle (C) and push the handle toward the windrower so
that the coupler locks onto the receptacle and knob (B)
pops out.
12. Remove the cover from electrical connector (E). Push the
electrical connector onto the receptacle. Secure the
connector by turning the collar on the electrical connector
clockwise.
13. Remove hose quick disconnect (F) from its storage location.
Connect the quick disconnect to the receptacle on
the frame.
NOTE:
Hose quick disconnect (C) is present only on the following
configurations:
• M2170 Windrowers equipped with the R1 Series
Hydraulic Drive kit (B6845)
• M2260 Windrowers configured for draper or auger
headers
14. Retrieve knife and reel drive multicoupler (A) from the
hydraulic hose management system.
15. Push knob (B) on the hydraulic receptacle and pull
handle (C) fully away from the windrower.
16. Open cover (D) and position the coupler onto the
receptacle. Align the pins in the coupler with the slots in
handle (C), and push the handle toward the windrower so
that the coupler locks onto the receptacle and knob (B)
snaps out.
262170
OPERATION
E
Figure 4.136: Draper/Reel Multicoupler
Figure 4.137: Knife/Reel Drive Multicoupler
189
A
B
D
A
D
B
C
F
C
Revision A