MacDon M2170 Operator's Manual page 166

8. Press switch (A) to turn on the lights.
NOTE:
Always use these lights on roads to provide warning to the
other vehicles.
9. Use high/low switch (B) as needed when other vehicles are
approaching.
IMPORTANT:
Do NOT use the field lights on the road; they may confuse
other drivers.
10. Press switch (C) to turn on the beacons.
11. Press switch (D) to turn on the hazard lights.
12. Set the desired maximum ground speed limit. For
instructions, refer to Adjusting Ground Speed Limit, page
131.
NOTE:
Maximum ground speed can be set while the windrower is
moving. Anticipate acceleration or deceleration if changing
maximum speed while moving.
13. Slowly push throttle (A) fully forward (operating speed).
WARNING
Ensure that all bystanders have cleared the area.
14. Move the ground speed lever (GSL) (B) out of PARK and
slowly forward to the desired speed.
262170
OPERATION
C
B
Figure 4.46: Light Switches
B
A
Figure 4.47: Console
142
D
A
Revision A