Replacing Beacon Lights; Replacing Cab Dome Bulb - MacDon M2170 Operator's Manual

Hide thumbs Also See for M2170:

Table of Contents

2. Turn the lights OFF.

3. Remove two hex flange bolts (A) from light (B), and remove

the light from the bezel.

4. Remove the electrical connector from light (B).

5. Connect the wiring harness to new light (B), and secure the

light to the bezel using two hex flange bolts (A).

Replacing Beacon Lights

If the beacon lights are damaged or burn out, they will need to be replaced.

1. Disconnect wiring (A) from the harness.

2. Remove nuts (B) and remove beacon (C). Discard the

defective beacon and hardware.

3. Clean any residue from support (D) mounting surface.

4. Install new beacon (C) with gasket (E) onto the support.

Secure it with bolts (F), washers (G), and nuts (B).

5. Torque the nuts to 0.65 Nm (5.75 lbf·in).

If the dome light in the cab ceiling burns out, it will need to be replaced.

To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the

key from the ignition before leaving the operator's seat for any reason.

1. Shut down the engine, and remove the key from the ignition.

MAINTENANCE AND SERVICING

Figure 5.220: Red Taillights

Figure 5.221: Beacon Light Assembly