One-Touch-Return Buttons - MacDon M2170 Operator's Manual

OPERATOR'S STATION

One-Touch-Return Buttons

The ONE-TOUCH-RETURN buttons A, B, C on the ground speed lever (GSL) save header configuration settings and serve as
presets for quickly returning the header to specific settings.
The ONE-TOUCH-RETURN buttons A, B, and C always save
header height settings, but the following settings can also be
saved depending on the header type:
• Header tilt
• Deck position/header float selection
• Double windrow attachment (DWA) or swath compressor
raise/lower
• DWA speed
• Knife speed
• Draper speed
• Reel speed
Figure 3.65: ONE-TOUCH-RETURN Buttons on GSL
• Reel height
• Reel fore-aft
• Disc speed
• Remote Baffle Control option
To program the ONE-TOUCH-RETURN buttons, press and hold button A, B, or C on the GSL handle for 3 seconds until an
audible tone is heard, indicating that the current header settings have been saved.
NOTE:
To return the header to a preset condition, tap the A, B, or C button quickly. Holding the ONE-TOUCH-RETURN button too
long can inadvertently reprogram the current header settings.
83
262170 Revision A