Preparing Windrower To Tow A Header - MacDon M2170 Operator's Manual

Hide thumbs Also See for M2170:

Table of Contents

• A windrower without a header or a weight box must NOT

be used to tow headers due to reduced traction and

possible loss of control.

• When towing equipment which is not equipped with brakes,

do NOT exceed 32 km/h (20 mph).

• To tow a header with a windrower, the header must be

equipped with the appropriate equipment to comply with

local regulations.

• Before towing, verify that the signal lighting and safety

equipment is installed and functioning properly.

• Do NOT exceed the combined gross vehicle weight (CGVW) specified in Table

• To prevent damage and loss of control, ensure the machine and the attached equipment are within the following

weight limits:

Table 4.3 Windrower Weight Specifications

Maximum GVW (includes

mounted implements)

Maximum CGVW (includes

towed and mounted implements)

Maximum weight on both caster

Preparing Windrower to Tow a Header

The instructions in this section will prepare you to safely tow a header with the windrower.

To prevent injury or death from the unexpected start-up of the machine, always stop the engine and remove the key

from the ignition before leaving the operator's seat for any reason.

Figure 4.52: Towing a Header

Figure 4.53: Maximum Weight