MacDon M2170 Operator's Manual page 183

Windrower
Hide thumbs Also See for M2170:
Table of Contents

Advertisement

5. Prepare the center-link as follows:
• If not equipped with the Center-Link Alignment kit:
Relocate pin (A) in the frame linkage as needed to raise
center-link (B) until the hook is above the attachment
pin on the header.
• If equipped with the Center-Link Alignment kit: Press
REEL UP switch (D) on the ground speed lever (GSL) to
raise the center-link until the hook is above the
attachment pin on the header.
IMPORTANT:
Ensure that the center-link is positioned high enough that it
does not contact the header as the windrower approaches
the header.
6. Press HEADER DOWN switch (C) on the GSL until the
windrower lift linkages are fully lowered.
7. Drive the windrower forward slowly, until feet (A) on the
windrower enter supports (B) on the header. Continue to
drive forward until the feet engage the supports and the
header is nudged forward.
262170
OPERATION
A
C
Figure 4.73: Center-Link without Self-Alignment
A
Figure 4.74: Header Support
159
B
D
B
Revision A

Advertisement

Table of Contents
loading

This manual is also suitable for:

M2260

Table of Contents