Adding Engine Oil; Engine Operation - MacDon M2170 Operator's Manual

Hide thumbs Also See for M2170:

Table of Contents

6. Remove the dipstick again. Check the oil level. The oil level

should be between the LOW (L) and HIGH (H) marks on the

dipstick. If the oil level is below the LOW mark, oil will need

to be added to the crankcase.

Adding 1.9 liters (2 U.S. quarts) of engine oil will raise the

level from LOW to HIGH. To add oil, refer to

7. Replace the dipstick. Turn the dipstick clockwise to lock it.

Adding Engine Oil

If the engine oil dipstick shows that the engine oil level is low, or if the oil has been drained, more oil will need to be added.

To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the

key from the ignition before leaving the operator's seat for any reason.

1. Shut down the engine, and remove the key from the ignition.

2. Open the hood. For instructions, refer to

3. Clean the area around filler cap (A). Turn the cap

counterclockwise to unlock it. Remove the cap.

4. Carefully pour in new oil. A funnel is recommended to

avoid spillage. For oil specifications, refer to

Lubricants, Fluids, and System Capacities, page

Do NOT fill above the HIGH mark.

5. Replace oil filler cap (A) and turn it clockwise until it is snug.

6. Check the oil level. For instructions, refer to

7. Close the hood. For instructions, refer to

To ensure the length of the windrower's service life, its engine needs to be started, operated, and shut down according to

the provided procedures.

Adding Engine

Figure 4.11: Engine Oil Level on Dipstick

5.3.1 Opening Hood, page

Figure 4.12: Oil Filler Cap

Checking Engine Oil Level, page

5.3.2 Closing Hood, page