Driving Forward In Cab-Forward Mode - MacDon M2170 Operator's Manual

Table 4.2 Selectable Ground Speed Limits
Direction of Travel
Cab-forward (standard drive wheel)
Engine-forward (standard drive wheel)
To adjust the windrower's ground speed limit, do the following:
1. From the HOME page of the HarvestTouch
outlined MAX WHEEL SPEED value (A) located right of the
Wheel Speed display. The MAX WHEEL SPEED adjustment
page opens.
2. Select the desired maximum wheel speed from the list (B).
NOTE:
The available settings will change depending on whether
the windrower is in the cab-forward or the engine-forward
mode, or if the High Torque Final Drive option is installed.
3. To save your selection, press the checkmark icon.

Driving Forward in Cab-Forward Mode

In cab-forward mode, the operator's station is facing away from the engine. The instructions in this section show how to
operate the windrower in the forward direction while in cab-forward mode.
WARNING
Do NOT drive the windrower on the road in the cab-forward
configuration unless it is equipped with the proper lighting and
markings for cab-forward road travel.
WARNING
Outside of North America, do NOT drive the windrower on the
road in cab-forward mode, as lighting/reflector visibility will not
be compliant with road regulations.
CAUTION
Operate both the steering wheel and the ground speed lever slowly for familiarization. Avoid the common tendency of
new Operators to oversteer.
11. The default setting is 17 km/h (10.5 mph).
12. The default setting is 44 km/h (27 mph). Maximum engine-forward (road) speed varies by region based on local
regulation. The limited regions are: Germany (30 km/h), France (25 km/h).
262170
OPERATION
11
17, 20, 23, 26, 29 km/h (10.5, 12, 14, 16, 18 mph)
12
™
Display, press
132
Selectable Ground Speed Limits
17, 29, 44 km/h (10.5, 18, 27 mph)
B
A
Figure 4.29: HarvestTouch
Figure 4.30: Cab-Forward Mode
™
Display
Revision A