Replacing Bulbs In Red And Amber Lights - MacDon M2170 Operator's Manual

Hide thumbs Also See for M2170:

Table of Contents

2. Disconnect wiring harness (A).

If you do NOT have to also replace hinge bracket (C), then

also replace hinge bracket (C), then remove mounting

nut (E) inside the cab roof. This task requires two people:

• All cab-forward work lights: Remove the cab-forward

sun shade. Open the access panel in the headliner to

access the work light mounting nuts. Tighten the

mounting nuts to 27 Nm (239 lbf·in).

• Two rear right work lights: One work light is mounted

externally and is readily accessible. To remove the

mounting hardware for the other work light, remove

the radio panel from the cab. Tighten the mounting

nuts to 15 Nm (133 lbf·in).

• Two rear left work lights: Contact your MacDon dealer

to have the headliner removed.

3. Remove bolt and nut (B) from hinge bracket (C).

4. Remove LED lamp assembly (D).

5. Mount new LED assembly (with its hinge bracket removed)

to existing hinge bracket (C) using bolt and nut (B).

6. Tighten the hinge nut to 7.5 Nm (66 lbf·in).

7. Reconnect the wiring harness.

Replacing Bulbs in Red and Amber Lights

If the red and amber lights burn out, they will need to be replaced.

To replace the bulbs in red and amber lights, follow these steps:

To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the

key from the ignition before leaving the operator's seat for any reason.

1. Turn the lights OFF.

2. Shut down the engine, and remove the key from the ignition.

MAINTENANCE AND SERVICING

487. If you have to

Figure 5.217: Front LED Work Light