Connecting R2 Series Rotary Disc Header Hydraulic And Electrical Systems - M2170 Windrower - MacDon M2170 Operator's Manual

Hide thumbs Also See for M2170:

Table of Contents

23. Proceed as follows:

• If attaching the header to an M2170 Windrower:

Systems – M2170 Windrower, page 229

• If attaching the header to an M2260 Windrower:

Systems – M2260 Windrower, page 234

Connecting R2 Series Rotary Disc Header Hydraulic and Electrical Systems – M2170 Windrower

Connecting the header hydraulic and electrical systems to the windrower involves attaching the header's knife drive,

pressure, return, case drain, and electrical connectors to the windrower's receptacles.

To prevent bodily injury or death from the unexpected start-up of the machine, always stop the engine and remove the

key from the ignition before making adjustments to the machine.

Do NOT stand on an unlocked platform. It is unstable and may cause you to fall.

To prevent contamination of the hydraulic system, use a clean rag to remove dirt and moisture from all (fixed and

movable) hydraulic couplers.

1. Shut down the engine, and remove the key from the ignition.

2. Approach platform (A) on the left side of the windrower.

Ensure that the cab door is closed.

3. Push latch (B) and pull platform (A) toward the walking

beam until it stops and the latch engages.

Connecting R2 Series Rotary Disc Header Hydraulic and Electrical

Figure 4.225: Left Platform

Troubleshooting