MacDon M2170 Operator's Manual page 194

6. Lower stand (A) by pulling clevis pin (B), inverting the stand
and relocating it on the bracket. Reinsert pin (B) and secure
it with the hairpin.
7. Windrowers with self-aligning center-link: Release center-
link latch (A).
8. Disengage the safety props on both lift cylinders as follows:
a. Turn lever (A) away from the header to raise the safety
prop until the lever locks into the vertical position.
b. Repeat the previous step for the opposite cylinder.
NOTE:
If the safety prop will NOT disengage, raise the header to
release the prop.
9. Start the engine.
262170
OPERATION
Figure 4.96: Header Stand
Figure 4.97: Center-Link
Figure 4.98: Safety Prop Lever
170
B
A
A
A
Revision A