5. Carefully insert a slotted screwdriver (or similar prying tool)
between the roof liner and the dome light assembly on the
side of the light with the ON/OFF switch.
6. Gently depress retaining clip (A), and swing the dome light
assembly downwards to disengage retaining tab (B).
7. Disconnect the old dome light assembly from the wiring
harness.
8. Connect the new dome light (MD #201707) to the
wiring harness.
9. Engage retaining tab (B), and swing the dome light
assembly upward until retaining clip (A) snaps into place
and secures the assembly.
10. Secure the dome light assembly with two screws (A).
11. Insert single retaining tab (A) into the dome light bezel.
12. Insert a slotted screwdriver (or similar prying tool) into
slot (B), and gently pry the lens cover until retaining
tabs (C) engage into the dome light bezel.
262170
MAINTENANCE AND SERVICING
Figure 5.227: Cabin Dome Light Assembly
Figure 5.228: Cabin Dome Light with Cover Removed
Figure 5.229: Cabin Dome Light
492
B
A
A
A
1015624
C
B
Revision A