Turn Signal Indicators; Accessing Circuit Breakers And Fuses - MacDon M2170 Operator's Manual

Hide thumbs Also See for M2170:

Table of Contents

Turn Signal Indicators

The turn signal indicator lights can be found on the operator's console. If the turn signal indicators are not working

correctly, contact your MacDon Dealer for more information.

Most circuit breakers and fuses are located inside a fuse box mounted on the left (cab-forward) side of the frame, behind

the platform and inside the battery cover.

The circuit breakers automatically reset. Fuses are the plastic blade type.

To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the

key from the ignition before leaving the operator's seat for any reason.

1. Shut down the engine, and remove the key from the ignition.

2. Open battery cover (A) to access the fuse box. For

instructions, refer to

Opening Battery Cover, page

3. Lift latch (A) at the top of fuse box cover (B) to disengage

the tab, and then lower the cover.

4. Check and replace the fuses as required. For instructions,

Checking and Replacing Fuses, page

5. Position cover (B) onto the fuse panel, ensuring that the

hooks at the bottom of the cover have engaged the

6. Push latch (A) to engage the tab at top of the fuse box.

7. Close the battery cover and move the platform to working

position. For instructions, refer to

MAINTENANCE AND SERVICING

5.4.2 Closing Platform,

Figure 5.230: Fuse Box Location

Figure 5.231: Fuse Box Cover