Pairing Bluetooth Device; Selecting Audio Source - MacDon M2170 Operator's Manual

Hide thumbs Also See for M2170:

Table of Contents

7. Rotate VOL/SEL knob (B) to display ON and press VOL/SEL

discovery will be active every time the radio is

turned off and back on.

Pairing Bluetooth

The installed radio allows the operator to pair a Bluetooth

1. Check that Bluetooth

Activating Bluetooth

2. Press POWER button (A) to turn the radio ON.

This will set the radio to Bluetooth

feature has been activated. If not, refer to the

radio operator's manual for instructions to access the

SETUP MENU, BT SET screen.

3. Turn the mobile device's Bluetooth

refer to the device's operator's manual. The radio appears

as a discoverable device.

4. Select VR-5650 on the mobile device.

A passkey is required to connect to the Bluetooth

The default passkey is four zeros (0000).

5. Enter the default passkey 0000. The radio will display

CONNECTED (B) and Bluetooth

upper right corner of the screen.

On the receiver, select the active media source when playing media from different sources.

1. Press POWER button (A) to turn the radio on.

2. Press SRC button (B) until the required audio source is

displayed (C) on the screen.

OPERATOR'S STATION

is enabled and that the radio has been set to DISCOVER mode. For instructions, refer to

Feature, page

discover mode if the

to ON. For instructions,

icon (C) appears in the

phone or audio device.

Figure 3.48: Radio Display

Figure 3.49: Bluetooth

Troubleshooting