Table of Contents
Advertisement
4. Select CALIBRATION (A).
5. Select POSITION (A).
NOTE:
Pressing X icon (A) on the screen (or pressing the HOME,
BACK or any GSL button [buttons not shown]) at any time
during the calibration process will EXIT the calibration
procedure without saving your progress. The engine speed
will also return to the original rpm prior to starting the
calibration process.
NOTE:
If a sensor goes out of its normal operating range during
the calibration process, calibration will stop and a message
will appear on the screen indicating that a sensor is out
of range.
262170
OPERATION
Figure 4.363: Setup Menu
Figure 4.364: Calibration Selection Page
Figure 4.365: Calibration Page
290
A
A
A
Revision A
Advertisement
Table of Contents
Troubleshooting
