Table of Contents
Advertisement
2. If the windrower was previously attached to an R85 or R216
Rotary Disc Header, make sure to remove the forming
shield (not shown), including forming shield support
brackets (A) and hardware (B) from both legs. You can store
the brackets and hardware in the windrower tool box.
• For instructions on removing the R216 forming shield,
refer to
Removing Forming Shield from the Windrower,
page
256.
3. Before beginning this procedure, make sure draper header
supports (A) are installed on both windrower lift linkages.
For instructions on installing the header supports onto the
windrower, refer to
Attaching Draper Header Supports,
page
198.
262170
OPERATION
A
Figure 4.162: Forming Shield bracket – R2 Series
A
Figure 4.163: Forming Shield bracket – R85
Figure 4.164: Header Supports Installed
200
B
B B
A
Revision A
Advertisement
Table of Contents
Troubleshooting
