Setting Draper Speed In Manual Mode - MacDon M2170 Operator's Manual

4. To set the draper index value, press arrows (C) beside
DRAPER INDEX and select a value within the adjustment
range: 0–8 km/h (0–5 mph) (zero—which is equal to ground
speed—is the default).
NOTE:
When ground speed is less than the set minimum draper speed, the draper operates at the draper minimum speed.
The minimum draper speed is displayed and "MIN" will replace AUTO and the index value.

Setting Draper Speed in Manual Mode

This adjustment requires the header to be engaged. The instructions in this section show you how to set the draper speed
in manual mode.
1. Engage the header to display header run screen 1 or 2, and
then press DRAPER SETTINGS icon (A).
2. To set draper speed control to manual, press DRAPER
SETTINGS icon (A) to access the DRAPER ADJUST page.
3. Set AUTO switch (A) to the OFF position.
262170
OPERATION
Figure 4.426: HarvestTouch
Screen
Figure 4.427: Draper Adjust Page
321
A
™
Display - Header Run
A
Revision A