Table of Contents
Advertisement
Attaching D2 Series Draper Header
The windrower's lift linkage and center-link will need to be connected to the header.
DANGER
To prevent bodily injury or death from the unexpected start-up or fall of a raised machine, always stop the engine and
remove the key before leaving the operator's seat, and always engage the safety props before going under the
machine for any reason.
DANGER
Ensure that all bystanders have cleared the area.
1. Shut down the engine, and remove the key from the ignition.
2. If the windrower was previously attached to an R85 or R216
Rotary Disc Header, make sure to remove the forming
shield (not shown), including forming shield support
brackets (A) and hardware (B) from both legs. You can store
the brackets and hardware in the windrower tool box.
• For instructions on removing the R216 forming shield,
refer to
Removing Forming Shield from the Windrower,
page
256.
262170
OPERATION
A
Figure 4.115: Forming Shield bracket – R2 Series
A
Figure 4.116: Forming Shield bracket – R85
178
B
B B
Revision A
Advertisement
Table of Contents
Troubleshooting
