MacDon M2170 Operator's Manual page 237

5. Remove header leg pin (B) by removing hairpin (A) from
header leg on both sides.
6. Lower header stand (D) by pulling spring loaded pin (C).
Release the spring pin to the lock stand.
7. Windrowers with self-aligning center-link: Release center-
link latch (A).
8. Disengage the safety props on both lift cylinders as follows:
a. Turn lever (A) away from the header to raise the safety
prop until the lever locks into the vertical position.
b. Repeat the previous step for the opposite cylinder.
NOTE:
If the safety prop will NOT disengage, raise the header to
release the prop.
9. Start the engine.
262170
OPERATION
A
B
Figure 4.190: Header Leg and Header Stand
Figure 4.191: Center-Link
Figure 4.192: Safety Prop Lever
213
C
D
A
A
Revision A