MacDon M2170 Operator's Manual page 191

12. If a rotary disc header is being replaced by an auger
header: Remove hose (A) from storage location (B).
Connect hose (A) to knife pressure receptacle (C) on
the frame.
NOTE:
Hose quick disconnect (C) is present only on the following
configurations:
• M2170 Windrowers equipped with the R1 Series
Hydraulic Drive kit (MD #B6845)
• M2260 Windrowers configured for draper or auger
headers
13. Remove the cover from receptacle (A). Connect the
header's electrical harness to the receptacle.
262170
OPERATION
A
B
A
Figure 4.89: Knife Pressure Hose Positions
1 - Hose in Storage Position (Rotary Configuration)
2 - Hose to Knife Pressure Receptacle (Auger/Draper Configuration)
Figure 4.90: Electrical Connectors
167
C
A
1
2
Revision A